Power Control Centers

PCC_Panels_1

Power Control Centre is used for distribution and control of various power source used in industry. Normally Power Control Centers is installed near power source hence fault level is high. It is designed to suit fault level of 50KA or 65 KA for 1 sec. Busbar system in Power Control Centers are designed to suit the fault level as well as temperature rise to 40°c above ambient. Ample space is provided for cable termination. Various protections viz short circuit, overload, earth fault, under voltage etc are provided to protect source and equipment.

We are engaged in manufacturing of power control centers from the best raw materials.We meet the requirements of International Standards along with compliance to local standards and regulations.

The complete structure shall be rigid, self supporting & free from twists and bends. The panels will be totally dust and vermin proof. They will have fixed or draw out type executions as many be desired.

Finish: The entire panel will undergo pretreatment covering decreasing, water rinsing & de-rusting/ phosphating. It will be synthetic enamel painted or powder coated as per requirements.

We are engaged in manufacturing of power control centers from the best raw materials.We meet the requirements of International Standards along with compliance to local standards and regulations.

The complete structure shall be rigid, self supporting & free from twists and bends. The panels will be totally dust and vermin proof. They will have fixed or draw out type executions as many be desired.

Finish The entire panel will undergo pretreatment covering decreasing, water rinsing & de-rusting/ phosphating. It will be synthetic enamel painted or powder coated as per requirements.

Bus Bars & Internal Wiring Uniform cross section copper Bus Bars (current density 1.39 amps/sq mm.) supported by SMC /DMC bases will be employed through out the length of the panel. Internal wiring be carried out with 11000/650 volt grade PVC insulated stranded conductor wire. All joints will be solidly crimped using copper thimbles Earthing Bus Bars will be running all along the board.

Switch Gears/ Components Along with the formal offer, the GA drawing and the bill of material will be submitted specifying the makes & capacities of all the material to be used in the panel. Standards Our Panels confirms to the standards such as, IS 4237; IS 8623; IS 375 Switch Gears/ Components Along with the formal offer, the GA drawing and the bill of material will be submitted specifying the makes & capacities of all the material to be used in the panel.